Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281
Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281
Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281
Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281
Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281
31. You get a CMOS checksum error during bootup. What is most likely the cause?
A. power supply is bad
B. BIOS needs updating
C. CMOS battery is nearing end of life
D. hard drive types are incorrectly defined
E. None of the above
32. On the 16-bit ISA bus, IRQ2 is elevated to which higher level interrupt?
A. 9
B. 11
C. 13
D. 15
E. None of the above
33. When measuring AC (Alternating Current) with a multimeter, it is important to maintain the proper polarity.
A. True
B. False
34. After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
A. MEM /P
B. MEMMAKER
C. MEM /C
D. SYS:
E. None of the above
35. What is a common language that computers use to talk with one another on a network
A. client
B. adapter
C. protocol
D. operating systems
E. None of the above
Warning: Undefined variable $in_same_cat in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/EXP.GKFEED.COM/function.php on line 27
Warning: Undefined variable $excluded_categories in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/EXP.GKFEED.COM/function.php on line 27