Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281

Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281

Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281

Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281

Warning: Undefined variable $ext in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/show-hidecollapse-expand/bg_show_hide.php on line 281

26. Which part of the laser printer should NOT be exposed to sunlight?

A. Transfer corona assembly
B. PC drum
C. Primary corona wire
D. Toner cartridge
E. None of the above

Show Answer

27. After doing a low-level format, what would be the next step in configuring the hard drive in a system?

A. Format DOS partition
B. Install operating system
C. Configure DMA channel and back-up interrupt
D. Partition had disk
E. None of the above

Show Answer

28. Resistance is measured in?

A. Volts
B. Amps
C. Watts
D. Ohms
E. None of the above

Show Answer

29. What command is used to reset a MODEM when using the “AT Command Set”?

A. ATR
B. ATZ
C. DTR
D. DCE
E. None of the above

Show Answer

30. When installing a SCSI CD-ROM drive, you must set the CD-ROM SCSI adapter to:

A. B0007
B. An unused SCSI address
C. The same address as the SCSI device before the CD-ROM
D. SCSI ID=1
E. None of the above

Show Answer
Warning: Undefined variable $in_same_cat in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/EXP.GKFEED.COM/function.php on line 27

Warning: Undefined variable $excluded_categories in /www/wwwroot/gkfeed.com/public_html/wp-content/plugins/EXP.GKFEED.COM/function.php on line 27